| How do I change the filters on my reverse osmosis system? |
| Before starting, shut off the cold water supply to the reverse osmosis system. If changing your reverse osmosis filters, lift the handle on the reverse osmosis faucet to drain out the storage tank completely and allow the system to stand for 10 minutes in order to fully decompress the tank. Some of the reverse osmosis water should be saved in a pitcher or clean bucket for cleaning and rinsing. 1. Remove prefilter housings by twisting and rotating them left, or counter clockwise. If the housings are too tight, a filter wrench may be necessary. 2. Slide out used filters and discard, but save "O" rings for re-use. 3. Wash out inside of all housings with a mild soap solution and then rinse with reverse osmosis water. 4. Lube "O" ring with a water-soluble lubricant (such as K-Y Jelly) and replace in groove in blue filter housing. 5. Insert new filters into appropriate housings. 6. Follow the normal Start Up procedures Home Page | FAQs | Glossary | Contact Us |